Well, it's been a while since I last updated this post. I decided to start small and work on the fuel drain cover first. I took the same approach as the fuel valve and used the red Coverite paint followed by the Coverite clear coat. Like I mentioned before it's a bit too glossy but this part is under the seat and isn't normally visible anyway. Below are some side by side images of the before and after parts. I needed to build up the underside of the new part to prevent the pulling of the lower hole like the old cover was. I built it up using cut off pieces of scrap held with epoxy. One down, many to go. The day before yesterday I also trimmed and placed the piece below the rear window, but more on that later.
